ABB Home and Building Automation - powered by phpMyFAQ 2.9.9

Tagged entries

HVAC
KNX

Add Search Word

Page 6 out of 11 Pages

FCC/S 1.x.x.1: Is it possible to use the same physical device input for several activated temperature limitations?
(130420 views)
FCC/S 1.x.x.1: What should be considered if weighting of internal and external measurement is set to 0%?
(129880 views)
FCC/S 1.x.x.1: Although the operation is enabled the fan stages in dependence of the control value do not switch. Why?
(145232 views)
FCC/S 1.x.x.1: There are no changes via i-bus tool possible. Config mode can´t be enabled. Why?
(129072 views)
What is the difference between an electric heater and an electric heater in the fan coil unit in the application parameters of FCC/S 1.x.x1?
(129749 views)
FCC/S 1.x.x.1: What´s the purpose of the parameter “Send inactive control values cyclically”?
(130800 views)
FCC/S 1.x.x.1: Why is the control value 0% if basic load is active?
(130103 views)
FCC/S 1.x.x.1: What must be considered if analog room control unit is deactivated in the parameter “setpoint adjustment”?
(145848 views)
FCC/S 1.x.x.1: Is the basic load active if dew point and fill level alarm has triggered in cooling mode?
(129114 views)
Since the BAC/S1.5.1 has an integrated Modbus RS485 interface is it possible to connect energy meters?
(132202 views)

[ previous ] [ next ]