ABB Home and Building Automation - powered by phpMyFAQ 2.9.9

Tagged entries

KNX
ClimaECO

Add Search Word

Page 4 out of 8 Pages

FCC/S 1.x.x.1: Why does the fan directly switch into the speed level depending on the control value if the fan mode is set to “step”?
(130468 views)
FCC/S 1.x.x.1: What is the summer compensation used for?
(129646 views)
FCC/S 1.x.x.1: How is the temperature limitation realized?
(129819 views)
FCC/S 1.x.x.1: Is it possible to use the same physical device input for several activated temperature limitations?
(130552 views)
FCC/S 1.x.x.1: What should be considered if weighting of internal and external measurement is set to 0%?
(130917 views)
FCC/S 1.x.x.1: Although the operation is enabled the fan stages in dependence of the control value do not switch. Why?
(146641 views)
FCC/S 1.x.x.1: There are no changes via i-bus tool possible. Config mode can´t be enabled. Why?
(129075 views)
What is the difference between an electric heater and an electric heater in the fan coil unit in the application parameters of FCC/S 1.x.x1?
(129751 views)
FCC/S 1.x.x.1: What´s the purpose of the parameter “Send inactive control values cyclically”?
(130857 views)
FCC/S 1.x.x.1: Why is the control value 0% if basic load is active?
(130107 views)

[ previous ] [ next ]