Advanced search

Based on the membrane keypad of the SAH/S x.x.7.x, how can you tell whether a channel is parametrized as a Switch Actuator or as a Shutter Actuator?

BA Engineering Team
20.03.2020 08:24

Pressing the "S” button changes between the respective output groups (A-D, E-H, etc.). After each change, the respective channel signals whether it has been parametrized as a Switch Actuator or as a Shutter Actuator in ETS. If the LEDs of a channel (up + down) flash at a frequency of 5 Hz, this signals Shutter mode. This brief indicating signal soon stops again, however.

If the channels are parametrized as a Switch Actuator, there is no flashing signal.

Information about this and many more valuable tips can be found in the manual for Combi Actuators at:
Link to manual

Tags: Blinds, KNX, Output
Average rating: 0 (0 Votes)

You cannot comment on this entry