What to do after a physical replacement of the free@home and Welcome 7" panel on a fully-programmed project?

Carolina Bachenheimer-Schaefer
05.01.2018 16:14

After a physical replacement of the free@home and Welcome 7" panel there are some few steps to follow. The procedure is the same for copying single devices in an existing programming.

Below document shows clear and simple step by step instructions on how to replace the free @ home / Welcome 7 "panel based on a fully-programmed project. The replace only takes a few seconds.

Replacement of the free@home®/Welcome 7" Panel 

Tags: free@home, Visualization
Average rating: 0 (0 Votes)

You cannot comment on this entry