Which electronic ballasts can be connected to the Analogue Actuator?

Carolina Bachenheimer-Schaefer
09.02.2017 13:31

LED converters with a 0-10 V interface can be connected.
LED converters are connected to a continuous voltage. Therefore, dimming down to the value 0 is possible via the 0-10 V interface. The Analogue Actuator drives the 0-10 V.
Electronic ballasts with 1-10 V active voltage are only conditionally controllable, because the 230 V must be switched on the electronic ballast. Using a Switch/Dim Actuator SD/S is recommended here.

Tags: DALI, KNX, TP
Average rating: 0 (0 Votes)

You cannot comment on this entry