Output of a logic does not send or only once

Arno Reinmuth
11.10.2016 13:24

In the default setting the exit is in ABL/S 1.1 is set on „send only with change in value“.  Only a  telegram is sent if the value changes in the output really. This setting is intended for it to minimize the telegram traffic on the KNX.

If the initial value does not change, e. g.  with the use of a filter function, the exit on every allocation is to be put. This setting can be put at the output of the logic directly.

Tags: KNX, Logic
Average rating: 0 (0 Votes)

You cannot comment on this entry